My Experience How to Argon Las and Construction of Argon Las Tool

How Argon welding Argon Construction Argon welding Argon or also called TIG, has previously been discussed in the article :: Understanding welding Argon :: This time will be discussed about how to weld argon. Argon welding system consists of connected resources that is welding with direct current or Back and welders connected to an electric current through a hose and cable packet. The hose and cable jacket carrying the supply of protective gas, cooling water, and the welding current. For the gas arc weld is the welding where the protective gas flow envelops and protects it from Adverse effects of air. The welding arc ignites in the non-melt tungsten tank natara and workpieces. Inert gases that will not cause chemical reactions, such as argon and helium or a mixture of shroud while protecting the tungsten and wolfram crater from the influence of water. ![image]
()

Information :

Electrical connectors or connectors
Welding current source and control unit (water cooling system using additional cooling tank, coolant circulation, and coolant pump)
Bottle of protective gas
Valve to regulate gas flow with gas flow meter
Welding control system welder
Protective gas channels
Welding current cable
Weld burner with button
Cable time and clip of workpiece
Tungsten electrode
Protective gas.
![image]
()

Procedure How to Argon Las

Things that need to be done when assembling argon welding method according to standard operational procedure (SOP) are:

Checking the condition of the welding component
Connect the slang pack to the welding machine, also the water cooling and gas connection
Connects back and forth reverse controls both the foot pedal system and the hand suit
Connect the time cord to the machine and the clamps to the desk or workpiece
Selecting the polarity of welding. The aluminum welding of the button is directed to alternating current (AC), while for welding steel and alloy steel is directed to direct current (DCEN)
Preparing tungsten electrodes
Assemble the welding burner, loosen the welding cap and also remove the tungsten from the burner. Removing the copper columns and nozzles from the burner. Installing the collet and its holder to the burner. Replace the nozle to the burner. Then install the welding wire into the welding compartment of the weld with the appearance of the end of the welding wire (electrode) 3-6 mm or not exceeding the inner diameter of the gas nozzle, and to seal the welding incendiary weld
Open the gas valve briefly to remove the dirt after making sure the gas is in a safe position. Install the gas regulator (gas flow regulator not yet opened) on the gas bottle. Connecting welding machine and slang. Check the density of the gas hose connection with soap water
Connect the main power connector, ensuring the power supply is connected to the machine. Connecting the outlet as per the manual procedure.
Turn on the main power connector, open the gas valve, then adjust the gas flow.
Ensuring workpiece for testing, arc ignition and strong current adjustment.
Upvote+follow me @balcheng