Cool drum robot, check out the movie and turn up the volume!

viralsteem (42)in #robot • 7 years ago

What it does? Basically:

Navigate around, collect some data, avoid obstacles, until it
Finds something "worth playing on" (a single isolated object or a wide flat surface that it can find an angle onto)
Snakes into place
Plays some beats on what it have found, and samples this, checking it has a "good sound"
Based on data collected in the area, and sample just made, then compose a little rhythm, and plays this along with the sample

Why? Well.. I was sitting thinking what I should do for my next robot, what it should do.. Listening to music.. making a rythm with some robot-parts.. Thought; "Hey, I will make a robot that drives around and plays on stuff"

Under neath is speaker and a microphone.

The speaker is used for beeps from the microcontroller, and to make click-sounds to the beat. The click-sounds are simply made by setting a pin high and then low straight after each oter. This way I can have the Microcontroller make sound to the music it is also playing, without using any time / causing delay.

The microphone (located on the stick between the two motors) is used to sample sounds and take input, measuring if the sticks are hitting anything or not.

Also it can be used to detect a foot stumping on the floor or someone clapping, and so the robot can find the speed of this after four beats, and play along / fall in to your clapping or stumping.

And.. It can be used when there are kids playing with the robot; Signals "Record", the kids shout, and the robot then plays music / a beat with their shouting as a part of "the music" :)

At the top there is another speaker. It is quite too large, I know, but I thought it looked cool :D Also because it is so torn and twisted, as I could not get it out of it´s old cabinet. On the top-speaker there is a red LED. It lights when the robot is recording, and gives a small blink when it is playing back a sample.

As said above, there is no servo on this robot. The head is also using the little motors from solarbotics. It was, however necessary to use some very thin wire to connect the SRF05, as it otherwise would sort of jam the head now and then if I was using my standard blue wire.

It was quite a fun challenge to make the rather complicated navigation and not having a servo, but only left /right/front to place the head, and then do the rest with the body.

The navigation is complicated because it is not just a matter of navigating around obstacles - that was the easy part. Second the robot has to find good places to drum; A single, isolated object, or a flat wall. Then the robot has to place itself on a good angle to the wall, or straight infront of the object.. All with only L/R/F with the head ;) But it does it quite well now! I am usually amazed of what it finds to play on, when I just let it drive around.

The robot runs for ever on just 4 cells. It must be because the belt-tracks are so geared that there is no strain on the motors.. And no servos, and the sampler takes nothing either.. I dont know, I just know that it runs for hours, more than my wife can stand to listen to - on one charge :D

In the center of this image is a L293D Motor driver. It is just used to enable the head to turn both ways.

Notice how easy it is to mount stuff with this glue; I just thought it would look good there on the side. Put some glue on, and stick it there. Hey, the cables are dangling.. Well.. press then onto the wood, and add a line of glue, bingo!

There is a blue print sticking out behind the wood from a cheese-container ;) That is "the sampler". It is actually this