You are viewing a single comment's thread from:

RE: Phill merchandize: 3D printing, removing supports and painting

in #print3d • 6 years ago

I Didn't knew that there were so much touch up need to complete before start the coloring. But it looks easy from the video, not sure when i started it would it be as easy as it look or it was a mess for me. Thank you for sharing the video.

Posted using Partiko Android

6 years ago in #print3d by
$0.00
    Reply 2
    Sort:  
  • Trending
    • [-]
     6 years ago 

    I dont know either , but i do know that I have been doing modelling and painting for the better part of 40 years, and it didnt look very good in the beginning

    $0.00
      Reply
      [-]
       6 years ago 

      40 years that long..This explained that you look so profesdional in the video

      Posted using Partiko Android

      $0.00
        Reply

        Coin Marketplace

        STEEM 0.16
        TRX 0.15
        JST 0.028
        BTC 54370.47
        ETH 2283.51
        USDT 1.00
        SBD 2.33