You are viewing a single comment's thread from:

RE: Introduction to 3D parametric modeling - Part I

in #parametric-modeling • 7 years ago

Hello and thank you very much for your reply and appreciation!
I used to work with Inventor, since I've got the certification on that software as well (but not since 2009, I started studying it only in 2014 eheh!). Then, I started learning Fusion 360 and I actually love it. Do you use it?
Thank you again!

7 years ago in #parametric-modeling by
$0.00
    Reply 0

    Coin Marketplace

    STEEM 0.17
    TRX 0.25
    JST 0.034
    BTC 98337.13
    ETH 2739.26
    SBD 0.63