Minnie Mouse to Crochet Hat

in #needleworkmonday5 years ago

coompleto.jpg
Source Photo taken by the author @xeliram in a cell phone

Greetings to all communities, welcome back to my blog. In this post I will introduce you step by step a baby hat of approximately 2 months, of minnie mouse, made in crochet. For the same use crochet thread black, red and white, knitting needle 3 mm, scissors and needle wool.


Start with the black thread to make the cap, performing the following steps:

  • V-1. Magic ring, 2 chains and 11 high points, closing with sliding point
  • V-2 weave 2 chains and a high stitch in the same hole, make 1 increase in each stitch until you finish the turn with 24 stitches, close with a sliding stitch.
  • V-3 knit 2 chains, 1 increase in the next stitch, 1 high stitch, 1 increase until finishing the turn, close with sliding stitch.
.


  • V-4 knit 2 chains, 1 high point, 1 increase, 2 high points, 1 increase to finish, close with a sliding stitch.
  • V-5 knit 2 chains, 2 high stitches, 1 increase, 3 high stitches, increase until the end of the turn and close with a sliding stitch.

Perform the same procedure up to a diameter of approximately 35 cm. Then perform 4 with a high point in each point and change the red color with 6 or 9 turns depending on the length you want with 1 high point in each turn and one last turn with half a low point.


parte de atras.jpg
Source Photo taken by the author @xeliram in a cell phone

Ears



For the elaboration of the ears, carry out two:

  • V-1 Magic ring with 12 low points and close with sliding point.
  • V-2 knit 1 chainchain and 1 low stitch in the same hole of the chainchain, increase each stitch and close with a sliding stitch.
Source Photo taken by the author @xeliram in a cell phone
.


  • V-3 1 chain, 1 increase, 1 low point, 1 increase, 1 low point repeat until you reach point 17, i.e. you have 7 points left to finish.
  • V-4 knit 1 chain and turn, 1 low point, 1 raise, 2 low points, 1 raise to where the previous turn started.
  • V-5, 6 1 chainsaw turn and make 1 high stitch for each stitch.
  • Close with a turn of low points.

Bow


  • Weave 20 chains, in the second point weave 1 low point, weave 1 low point for each stitch turn in each turn, make 6 to 10 turns, and take in each turn only the back loop so that it is in relief.
    For the white wheels, make it in a spiral:
  • Turn 1. 6 low points in a magic ring. (6 points).
  • Turn 2. 1 increase for each point (12)
  • Lap 3. 1 low, 1 increase (18)

coompleto.jpg
Source Photo taken by the author @xeliram in a cell phone

If you liked this publication, leave a comment or follow me on @tiendaxeliram


Note: The photos were taken by the author @xeliram



by @crosheille



I am Marilex Porteles, Mathematics teacher, researcher, dreamer, I like weaving, swimming and I am the mother of a beautiful girl.

Give UPVOTE if you like, COMMENT and RESTEEM for others to know THANK YOU.


Sort:  

Congratulations! Your post has been selected and you have received an upvote from the Steemitmamas community account. Thank you for contributing great content!

This is a curation initiative supported by the @steem-hodler tribe

20180516_002249_0001.png

Thanks for the support.

Hello @xeliram, thank you for sharing this creative work! We just stopped by to say that you've been upvoted by the @creativecrypto magazine. The Creative Crypto is all about art on the blockchain and learning from creatives like you. Looking forward to crossing paths again soon. Steem on!

Thanks for the support.

Coin Marketplace

STEEM 0.19
TRX 0.13
JST 0.030
BTC 59722.01
ETH 3267.61
USDT 1.00
SBD 2.36