Aggroed and R0nd0n explore a GEET engine running on a gasoline and water mix with Remy and look to next steps!

in #geet7 years ago

On the Minnow Mayor Town Hall I invited David Pantone and Remy Marco to speak about a "GEET" engine. The claims of the GEET engine are:

  1. It creates a high temperature front and a low temperature front
  2. Those fronts meet at a metal or glass rod
  3. The rod ionizes essentially from static electricity
  4. The fuel mixture running over the ionized rod will create a plasma and the fuel undergoes electrolysis. In the case of water it creates hydrogen gas.
  5. The standard internal combustion engine burns some combination of gasoline vapors, hydrogen gas, and oxygen.

I was convinced enough to try some more experiments

From what I saw and heard I am convinced enough to buy a generator, put it on my property, and try to measure efficiency, fuel use, output, and other metrics.

The main thing I heard that convinced me was how when there was an electric draw on the RV I could hear the generator react. Both R0n and I were convinced the RV was pulling a load on the generator.

The main thing I saw that convinced me was after he took the rod out of the GEET engine the rod displayed some truly bizarre magnetic behavior. I can't underscore this enough. It was bizarre! He took the rod out and the rod was ionized. You can tell because a compass would realign to face N or S depending on which pole of the rod he was measuring. That's weird because there's nothing about combustion that would make me think it would ionize a rod. More importantly though is that the magnetic properties of the rod were weird. The part of the rod furtherst from the Earth was the North pole. If he flipped the rod upside down the pole of the rod shifted. That's weird!

Magnetic pole shifts like that aren't normal

Consider a big red horseshoe magnet for a second. The orientation to the earth doesn't change which pole is which. I can move it however and those atoms are locked in place. The field around the magnet changes as I rotate it, but the North Pole and South Pole don't just switch sides. The pole on this rod changed due to orientation to the earth.

I'm not sure what causes that. I don't think I've ever seen that behavior before. It was much less prevalent on the glass rod than on the metal rod, but if you squint it might be present. Tough to know from one short test. As a chemist I can't think of what would cause this. My best guess is that there are particles on the surface of the rod that get ionized and are mobile. Presumably the negative ones are slightly heavier and when the rod is rotated they move towards the bottom of the rod and the electrostatic interactions push the positive ones up. I don't know that for sure, but that would be my leading hypothesis because I don't know of other rigid metal magnets that are able to switch poles by changing orientation to the Earth.

I don't think things that gets ionized from static electricity will usually have a rotating pole like this. I have more research to do.

So, the plan:

R0n is an electrician and we'll work to hook up an external generator to my house. Remy will modify that generator using a couple hundred bucks worth of parts from a machine shop and Home Depot to convert it to a GEET engine. We'll either run a separate load of some heaters and ASIC miners to test it or we'll run the house on the generator. I'll try to measure the amount of fuel consumed and see if I can get a baseline of information. Then we'll get Remy to GEET 'er done and measure the delta in performance and consumption.

The most likely worst case scenario is I have a new generator that I just took out of warranty (which maybe means I should try to find an old generator off of Craig's list) by modifying it. Best case scenario I help spread a technology that converts water into electricity using fairly inexpensive equipment and cheap fuel.

We'll see?!?!?!?!?

Sort:  

It was a pleasure to have you here for this demonstration of the GEET unit on a generator. Thank you for bringing your crew to see it run and to take some measurements. David (@geetinstitute, @davidpantone) and I are looking forward to working with you and getting a genset up and running at your place!

Glad to see your achievement.I don't have enough knowledge in the engineering but I always admired the creative people ...like above.

Thank you @aggroed and @r0nd0n for exploring the Geet technology. Its very interesting and the magnetized rod is peculiar. However, I saw a lot of fuel poured into that jar and probably less than 8 ounces of water and HI-C (the addition of Hi-C, Pepsi or Urine etc is nothing more than a parlor trick meant to distract from the minimal amount of additional liquid they are adding to the fuel). The fuel mixture (looked about 5 to 1) should be done with clear measuring cups so a quantifiable assessment can be made. I'm guessing that a small percentage of water and sugar in a bubbler filled with fuel has a negligible effect on an engine and fuel efficiency. I hope I'm wrong but nothing in this experiment makes me believe that you can save money on fuel with a Geet modified generator. @aggroed definitely go with the used generator from Craig's List.

That's one big RV. Great vids, had fun watching it. Great to see Aggroed as well. At least put some popcorn in that Microwave, R0ndon _

Interesting indeed, looking forward to reading your results. a GEET engine you say, hmm very interesting.

That's awesome, am curious about magnetism and electricity specifically because they help humanity came out with such a grat things like MRI, I heard that too many companies work on this project (converts water into electricity) we don't have to pay tons of money for electricity to light our lives it's a free energy peace upon Nikola Tesla but just like everything in this world business is everywhere and we got nothing for free but the future is brighter I believe in the world of cryprocurrencies and solar energy, virtual reality and AI .
the great is yet to come @aggroed

I’ve seen these videos around before. They are compelling. And I’ve also seen vids that claim it’s a scam. It’s got my curiosity piqued.

I will be following your progress. I have a few motors lying around I could try this with. Would love to put it in a bike and see what happens.

You guys are doing an amazing job. I Iove reading about researches on free energy and I'll definitely read more on this.

Thanks for sharing was transpired at the Minnow Mayor Town Hall.

Happy Steeming

Great video, good job, u have my vote ;)

Mehnn.. That's some really deep engineering there..nice onee

Coin Marketplace

STEEM 0.19
TRX 0.19
JST 0.033
BTC 90237.77
ETH 3102.10
USDT 1.00
SBD 2.81